User manual

Remote Control
R&S
®
RTO
469User Manual 1316.0827.02 ─ 06
TRIGger<m>:INTerval:POLarity.......................................................................................469
TRIGger<m>:INTerval:RANGe........................................................................................469
TRIGger<m>:INTerval:WIDTh.........................................................................................469
TRIGger<m>:INTerval:DELTa.........................................................................................470
TRIGger<m>:INTerval:POLarity <Polarity>
Indicates the polarity of a pulse, that is the direction of the first pulse slope.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event, 3 = R-event.
Parameters:
<Polarity> POSitive | NEGative | EITHer
See chapter 16.2.2.4, "Polarity Parameter", on page 420.
*RST: POSitive
TRIGger<m>:
INTerval:RANGe <RangeMode>
Defines the range of an interval in relation to the interval width specified using 
TRIGger<m>:INTerval:WIDTh and TRIGger<m>:INTerval:DELTa.
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<RangeMode> WITHin | OUTSide | SHORter | LONGer
WITHin
Triggers on pulses inside a given range. The range is defined by
the interval width ±delta.
OUTSide
Triggers on pulses outside a given range. The range is defined by
the interval width ±delta.
SHORter
Triggers on pulses shorter than the given interval width.
LONGer
Triggers on pulses longer than the given interval width.
*RST:
OUTSide
TRIGger<m>:INTerval:WIDTh <Width>
Defines the time between two pulses.
Command Reference