User manual

Remote Control
R&S
®
RTO
466User Manual 1316.0827.02 ─ 06
Parameters:
<Level> Range: -10 to 10
Increment: 1E-3
*RST: -0.1
Default unit: V
TRIGger<m>:WINDow:RANGe <RangeMode>
Defines the signal run in relation to the window:
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<RangeMode> ENTer | EXIT | WITHin | OUTSide
ENTer
Triggers when the signal crosses the upper or lower level and thus
enters the window made up of these two levels.
EXIT
Triggers when the signal leaves the window.
WITHin
Triggers if the signal stays between the upper and lower level for
a specified time. The time is defined using the TRIGger<m>:
WINDow:TIME command.
OUTSide
Triggers if the signal stays above the upper level or below the
lower level for a specified time. The time is defined using the 
TRIGger<m>:WINDow:TIME command.
*RST:
ENTer
TRIGger<m>:WINDow:TIME <TimeRangeMode>
Defines the limit of the window in relation to the time specified using TRIGger<m>:
WINDow:WIDTh and TRIGger<m>:WINDow:DELTa. Time conditioning is available for 
TRIGger<m>:WINDow:RANGe= "WITHin" and "OUTSide".
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Command Reference