User manual

Remote Control
R&S
®
RTO
459User Manual 1316.0827.02 ─ 06
Parameters:
<Filter> OFF | LFReject | RFReject
OFF
The trigger signal is not filtered.
LFReject
Frequencies higher than the "Cut-off" frequency are rejected,
lower frequencies pass the filter.
You can adjust the "Cut-off" frequency using the TRIGger<m>:
ANEDge:CUToff:LOWPass command, the default is 50 kHz.
RFReject
Frequencies below the "Cut-off" frequency are rejected, higher
frequencies pass the filter.
You can adjust the "Cut-off" frequency using the TRIGger<m>:
ANEDge:CUToff:HIGHpass command, the default is 50 kHz.
*RST:
OFF
TRIGger<m>:ANEDge:GND <Ground>
Connects the analog signal to the ground.
Suffix:
<m>
.
1..3
Only suffix 1 = A-event is allowed, the analog edge trigger is not
available for B- and R-events.
Parameters:
<Ground> ON | OFF
*RST: OFF
TRIGger<m>:ANEDge:SLOPe <Slope>
Sets the edge for the trigger event.
Suffix:
<m>
.
1..3
Only suffix 1 = A-event is allowed, the analog edge trigger is not
available for B- and R-events.
Parameters:
<Slope> POSitive | NEGative
See chapter 16.2.2.3, "Slope Parameter", on page 420.
*RST: POSitive
Glitch Trigger
The glitch trigger is not available for the B-event (Suffix = 2).
TRIGger<m>:GLITch:POLarity........................................................................................460
TRIGger<m>:GLITch:RANGe..........................................................................................460
Command Reference