User manual

Remote Control
R&S
®
RTO
456User Manual 1316.0827.02 ─ 06
TRIGger<m>:ROBust <Robust>
The "robust trigger" setting is relevant for all trigger types with an event condition that is
based on the time difference between a rising and a falling edge. These trigger types are:
glitch, width, runt, timeout, window, data2clock, pattern, and serial pattern. It avoids an
undefined state of the trigger system that might occur due to hysteresis, for example,
when triggering on the envelope of a modulated signal.
See also: "Robust trigger" on page 61
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event, 2 = B-event, 3 = R-event.
Parameters:
<Robust> ON | OFF
*RST: OFF
TRIGger<m>:ECOupling <TrigLevEvtCoup>
Sets the trigger levels of the channels to the values of the indicated event.
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event (reset event).
Parameters:
<TrigLevEvtCoup> ON | OFF
*RST: ON
TRIGger<m>:SCOupling <TrigLevSrcCoup>
Sets the trigger levels of all channels to the value of channel 1 for the indicated trigger
event.
Suffix:
<m>
.
1..3
Indicates the trigger event in a trigger sequence: 1 = A-event, 2 =
B-event, 3 = R-event (reset event).
Parameters:
<TrigLevSrcCoup> ON | OFF
*RST: OFF
Edge Trigger
TRIGger<m>:EDGE:SLOPe............................................................................................457
TRIGger<m>:ANEDge:COUPling.....................................................................................457
TRIGger<m>:ANEDge:CUToff:HIGHpass.........................................................................457
TRIGger<m>:ANEDge:CUToff:LOWPass.........................................................................458
TRIGger<m>:ANEDge:FILTer.........................................................................................458
Command Reference