User manual

Remote Control
R&S
®
RTO
454User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Parameters:
<SourceDetailed> CHANnel1 | CHANnel2 | CHANnel3 | CHANnel4 | EXTernanalog |
SBUS | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 |
D12 | D13 | D14 | D15 | LOGIC | MSOB1 | MSOB2 | MSOB3 |
MSOB4
CHANnel1...4
Input channels
EXTernanalog
External analog signal connected to the External Trigger Input on
the rear panel. For this source, only the analog edge trigger is
available.
SBUS
Serial bus
D0...D15
Digital channels (option R&S RTO-B1)
LOGIc
Logic combination of digital channels, used as trigger source
(option R&S RTO-B1)
MSOB1 | MSOB2 | MSOB3 | MSOB4
Parallel bus (option R&S RTO-B1)
*RST:
CHANnel1
TRIGger<m>:TYPE <Type>
Selects the trigger type for the trigger event.
See also: chapter 3.3.1, "Events", on page 58.
Suffix:
<m>
.
1..3
Indicates the event in a trigger sequence: 1 = A-event, 2 = B-event,
3 = R-event.
Command Reference