User manual

Remote Control
R&S
®
RTO
451User Manual 1316.0827.02 ─ 06
The filter value is applied to two channels in R&S RTO1022 and R&S RTO1024, or
applied to all available channels in R&S RTO1012 and R&S RTO1014.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<CutOffLP> Range: 100E+3 to 4E+9
Increment: 1000
*RST: 1E+6
Default unit: Hz
TRIGger<m>:COUPling <DigitalTrigCoup>
Selects the filter for the trigger channel(s). Other channels must use the same filter, or
proceed unfiltered.
Suffix:
<m>
.
1..3
Parameters:
<DigitalTrigCoup> OFF | RFReject
OFF
The trigger signal is not filtered.
RFReject
Frequencies higher a given limit are rejected, lower frequencies
pass the filter. The limit is set with TRIGger<m>:RFReject<n>.
*RST: OFF
TRIGger<m>:RFReject<n> <RejectBandwidth>
Sets the limit frequency, if the trigger coupling is set to RFReject. See TRIGger<m>:
COUPling.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event, 2 = B-event, 3 = R-event.
Parameters:
<RejectBandwidth> Range: 100E+3 to 4E+9
Increment: 1000
*RST: 1E+6
Default unit: Hz
16.2.5.8 Skew
CHANnel<m>:SKEW:MANual.........................................................................................452
CHANnel<m>:SKEW:TIME.............................................................................................452
Command Reference