User manual

Remote Control
R&S
®
RTO
443User Manual 1316.0827.02 ─ 06
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<PredefinedProbe> ZC10 | ZC20 | FREE
ZC10 | ZC20
Current probe R&S RT-ZC10 or R&S RT-ZC20
FREE
Any other probe that is not recognized by the instrument.
*RST: FREE
Firmware/Software: V 1.27
PROBe<m>:SETup:ATTenuation:UNIT <ProbeAttUnit>
Sets the unit for the connected probe type if PROBe<m>:SETup:ATTenuation:MODE
on page 442 is set to MANual.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<ProbeAttUnit> V | A | W
Voltage probe (V), current probe (A), power probe (W)
*RST: V
PROBe<m>:SETup:ATTenuation:MANual <ProbeAttModeManual>
Sets the attenuation for the connected probe if PROBe<m>:SETup:ATTenuation:
MODE on page 442 is set to MANual.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<ProbeAttModeManual>Range: 0.1 to 10000
Increment: 1
*RST: 10
Default unit: V/V
PROBe<m>:SETup:GAIN:MANual <ProbeGainModeManual>
Sets the gain of a current probe.
Suffix:
<m>
.
1..4
Command Reference