User manual

Remote Control
R&S
®
RTO
435User Manual 1316.0827.02 ─ 06
<n> 1..3
Selects the waveform. For each channel, up to three waveforms
can be analyzed. If WAVeform<n> is omitted, waveform 1 is
adressed.
Parameters:
<TrArith> OFF | ENVelope | AVERage
OFF
The data of the current acquisition is recorded according to the
decimation settings.
ENVelope
Detects the minimum and maximum values in an sample interval
over a number of acquisitions. To define the reset method, use ...
AVERage
Calculates the average from the data of the current acquisition and
a number of acquisitions before. To define the number of acquis-
itions, use ACQuire:COUNt.
*RST:
OFF
ACQuire:COUNt <MaxAcqCount>
The acquisition and average count has a double effect:
●
it sets the number of waveforms acquired with RUNSingle.
●
it defines the number of waveforms used to calculate the average waveform, and
Parameters:
<MaxAcqCount> Range: 1 to 16777215
Increment: 10
*RST: 1
ACQuire:SEGMented:STATe <State>
Switches the Ultra Segmentation mode on and off.
See also: chapter 2.3.1.4, "Ultra Segmentation", on page 35.
Parameters:
<State> ON | OFF
*RST: OFF
ACQuire:SEGMented:MAX <MaxAcquisitions>
The number of acquisitions in a Ultra Segmentation acquisition series depends on the
record length.
Command Reference