User manual

Remote Control
R&S
®
RTO
434User Manual 1316.0827.02 ─ 06
<n> 1..3
Selects the waveform. For each channel, up to three waveforms
can be analyzed. If WAVeform<n> is omitted, waveform 1 is
adressed.
Parameters:
<State> ON | OFF
*RST: OFF
CHANnel<m>[:WAVeform<n>]:TYPE <DecimationMode>
Selects the method to reduce the data stream of the ADC to a stream of waveform points
with lower sample rate.
See also:"Decimation" on page 34.
Suffix:
<m>
.
1..4
Selects the input channel.
<n> 1..3
Selects the waveform. For each channel, up to three waveforms
can be analyzed. If WAVeform<n> is omitted, waveform 1 is
adressed.
Parameters:
<DecimationMode> SAMPle | PDETect | HRESolution | RMS
SAMPle
One of n samples in a sample interval of the ADC is recorded as
waveform point.
PDETect
Peak Detect: the minimum and the maximum of n samples in a
sample interval are recorded as waveform points.
HRESolution
High resolution: The average of n sample points is recorded as
waveform point.
RMS
The waveform point is the root mean square of n sample values.
*RST:
SAMPle
CHANnel<m>[:WAVeform<n>]:ARIThmetics <TrArith>
Selects the method to build the resulting waveform from several consecutive acquisitions
of the signal.
See also: "Wfm Arithmetic" on page 34.
Suffix:
<m>
.
1..4
Selects the input channel.
Command Reference