User manual

Remote Control
R&S
®
RTO
431User Manual 1316.0827.02 ─ 06
ACQuire:POINts:ARATe.................................................................................................432
ACQuire:SRATe............................................................................................................432
ACQuire:RESolution.......................................................................................................432
ACQuire:POINts[:VALue]................................................................................................432
ACQuire:MODE.............................................................................................................433
ACQuire:INTerpolate......................................................................................................433
CHANnel<m>[:WAVeform<n>][:STATe]............................................................................433
CHANnel<m>[:WAVeform<n>]:TYPE...............................................................................434
CHANnel<m>[:WAVeform<n>]:ARIThmetics.....................................................................434
ACQuire:COUNt............................................................................................................435
ACQuire:SEGMented:STATe..........................................................................................435
ACQuire:SEGMented:MAX.............................................................................................435
AUToscale
Performs an autoset process: analyzes the enabled channel signals, and obtains appro-
priate horizontal, vertical, and trigger settings to display stable waveforms.
Usage:
Event
Asynchronous command
ACQuire:POINts:AUTO <RecLengthManual>
Selection to keep constant either the resolution or the record length when you adjust the
time scale (TIMebase:SCALe) or acquisition time (TIMebase:RANGe).
Parameters:
<RecLengthManual> RESolution | RECLength
RESolution
Resolution is kept constant. Set the required resolution value with
ACQuire:RESolution.
RECLength
The record length is kept constant. Set the required record length
value with ACQuire:POINts[:VALue].
*RST: RESolution
ACQuire:POINts:MAXimum <RecLengthLim>
Sets a limit for the record length to prevent very large records. This value only takes effect
if a constant resolution is selected with ACQuire:POINts:AUTO. If you increase the
time scale, the resolution remains constant and the record length increases until the limit
is reached. Further increase of the time scale changes the resolution and keeps the
record length limit.
Parameters:
<RecLengthLim> Range: 1000 to 1000000000
Increment: 2
*RST: 1000000
Default unit: Sa
Command Reference