User manual

Remote Control
R&S
®
RTO
430User Manual 1316.0827.02 ─ 06
Parameters:
<Offset> Range: -500 to 500
Increment: 0.01
*RST: 0
Default unit: s
TIMebase:REFerence <ReferencePoint>
Sets the reference point of the time scale in % of the display. The reference point defines
which part of the waveform is shown. If the "Trigger offset" is zero, the trigger point
matches the reference point.
See also: TIMebase:POSition on page 429
Parameters:
<ReferencePoint> The reference point is the zero point of the time scale.
Range: 0 to 100
Increment: 1
*RST: 50
Default unit: %
TIMebase:ROLL:ENABle <Mode>
Activates the automatic roll mode.
Parameters:
<Mode> AUTO | OFF
AUTO: the instrument activates the roll mode under specific con-
ditions.
See: "Mode" on page 29
*RST: AUTO
TIMebase:ROLL:MTIMe <MinHorizGain>
The roll mode is enabled automatically if the acquisition time exceeds the given value,
and if TIMebase:ROLL:ENABle is set to AUTO.
Parameters:
<MinHorizGain> Treshold value for roll mode enabling.
Range: 1 to 600
Increment: 1
*RST: 10
Default unit: s
16.2.5.3 Acquisition
AUToscale....................................................................................................................431
ACQuire:POINts:AUTO...................................................................................................431
ACQuire:POINts:MAXimum.............................................................................................431
Command Reference