User manual

Software and Network Operation
R&S
®
RTO
375User Manual 1316.0827.02 ─ 06
To install an option using a license key
1. Press the SETUP key and select the "SW options" tab.
2. If you received a key in written form, enter the key in the "Enter new option key" field.
If you received a key in digital form as a file, enter the path and file name in the "Install
from file" field and tap "Load". Alternatively, tap "Open" to open the file selection dialog
box and select the option key file.
3. If you want to enable several options, repeat step 2 for each option.
4. Restart the instrument or restart the firmware.
The functions of the additional option are available for use in your instrument.
The information provided in the "Option list" is for administration and troubleshooting
purposes only. Should you require support for the option, provide this information to the
service representative.
See also: chapter 13.2.1.3, "SW Options", on page 365
14.3.1 Mode
The MODE key opens a dialog box to activate options with beta-release state. These
options are deactivated by default. If you want to use a beta-released option, you must
activate it. The activation is effective until the next shut-down of the firmware.
Software Options