User manual

Software and Network Operation
R&S
®
RTO
374User Manual 1316.0827.02 ─ 06
5. If the name of the file that contains the update is already displayed in the "Select
Setup for firmware update" field, tap "Load".
Otherwise tap "Open" to open the file selection dialog box and select the
Setup*.exe file.
6. Select "Next" in the installation dialog box and select the firmware packages. By
default, all packages are installed.
7. Tap "Install" to start the update.
8.
After the firmware update, the R&S RTO reboots automatically.
9. Depending on the previous firmware version, a reconfiguration of the hardware might
be required during the first startup of the firmware. The reconfiguration starts auto-
matically, and a message box informs you about the process. When the reconfigu-
ration has finished, the instrument again reboots automatically.
Note: Do not switch off the instrument during the reconfiguration process!
Now the firmware update is complete. It is recommended that you perform a self-
alignment after the update ("File > Selfalignment").
The self-alignment procedure is described in the "Getting Started" manual, chapter
"Setting Up the Instrument".
14.3 Software Options
Additional options for the R&S RTO can be enabled using a license key. To obtain the
license key, consult your sales representative. You need the material number and serial
number of your instrument to get a license key. No additional installation is required.
Software Options