User manual

General Instrument Setup
R&S
®
RTO
366User Manual 1316.0827.02 ─ 06
Install from file
Alternatively to entering the option key manually, it can be read from a special option file
provided with the option.
Load ← Install from file
Loads the specified file.
Open ← Install from file
Opens a file selection dialog box and loads the selected file.
13.2.1.4 HW Options
This tab provides information on the availability of hardware options.
13.2.1.5 Remote Settings
The settings on this tab are required for remote control of the instrument via a connected
computer, see chapter 16.1, "Basics", on page 389.
Address
Indicates the GPIB address of the instrument if an optional GPIB bus card is installed.
The address can be edited here; however, beware that changing the address has major
effects on the communication to the remote computer. For details see chapter 16.1,
"Basics", on page 389.
Terminator
Specifies which symbol is used as a terminator in GPIB communication.
Transfer data format
Defines the format for data export with commands:
● CHANnel<m>[:WAVeform<n>]:DATA[:VALues]
● CALCulate:MATH<m>:DATA[:VALues]
● REFCurve<m>:DATA[:VALues]
"Ascii"
Data values are returned in ASCII format.
Reference for General Instrument Settings