User manual

General Instrument Setup
R&S
®
RTO
362User Manual 1316.0827.02 ─ 06
System
Opens the standard Windows "System Properties" dialog box to configure system set-
tings.
Network
Opens the standard Windows "Network Connections" dialog box to configure a network.
Screensaver
Opens the standard Windows "Display Properties" dialog box to configure a screensaver.
Time, date
Opens the standard Windows "Date and Time Properties" dialog box to set the correct
date and time.
Note: Usually date and time are set correctly. To adjust your regional time, select the
correct time zone rather than changing the time.
SCPI command:
SYSTem:DATE on page 768
SYSTem:TIME on page 768
Log on as
Sets the user that is automatically logged on during the startup process of the instrument.
The change of this setting takes effect at the next instrument startup
"User autolo-
gon"
Auto-logon as standard user with limited access. Enter the "User
name" and "Password" of the user who will log on at the next instrument
startup.
"Admin autolo-
gon"
Auto-logon with unrestricted access to the instrument and network. The
setting is only available for adminstrators. Enter the administrator
"Password" to enable the auto-logon.
"None"
No auto-logon, user name and password are requested at instrument
startup.
Select Setup for firmware update
Performs the firmware update.
See also: chapter 14.2, "Firmware Update", on page 373.
Load ← Select Setup for firmware update
Loads the specified file.
Open ← Select Setup for firmware update
Opens a file selection dialog box and loads the selected file (Setup_*.exe).
13.2.1.2 Screen
The settings on this tab are related to the screen display.
Reference for General Instrument Settings