User manual

Data and Results Management
R&S
®
RTO
353User Manual 1316.0827.02 ─ 06
"Manual"
Saves the data between user-defined "Start" and "Stop" values.
SCPI command:
EXPort:WAVeform:SCOPe on page 760
EXPort:WAVeform:STARt on page 761
EXPort:WAVeform:STOP on page 761
EXPort:WAVeform:ZOOM on page 761
EXPort:WAVeform:CURSorset on page 761
EXPort:WAVeform:MEAS on page 762
Data logging / Multiple Wfms
"Data logging" enables the export of all waveforms of a running acquisition into one file.
The waveform records are written in historical order one after the other, either the com-
plete records or the sections as defined in "Scope". Set the number of acquisitions to be
acquired and stored with "Acq. count". The maximum amount of data that can be written
is shown in "Max. file size".
If "Export history" is enabled, the option "Multiple Wfms" allows aou to save several or all
history waveforms.
SCPI command:
EXPort:WAVeform:DLOGging on page 762
Export history
Enables the history mode and allows to save history waveforms to file.
To save one waveform out of the history, enter the number of the required acquisition in
"Acq index".
To save several subsequent history waveforms, enable "Multiple Wfms" and define the
range of the waveforms to be saved with "Start acq" and "Stop acq". Start the history
replay and simultaneous saving with "Start Export".
Start Export
Starts an Nx Single acquisition serie and simultaneous saving if the waveform data to a
file.
If "Export history" is enabled, the button starts the history replay and simultaneous saving.
Save to file
Enter the file name to save the waveform to. Double-tap the file name to open the file
selection dialog box.
By default, the file name has the prefix "RefCurves_". You can define a pattern for auto-
matic naming in the "Autonaming" tab.
"Save"
Saves the waveform as a reference waveform in the selected file.
"Save As..."
Opens the file selection dialog box and saves the waveform to the
selected file. See also chapter 12.2.4, "File Selection Dia-
log", on page 355
Reference for FILE Settings