User manual

Data and Results Management
R&S
®
RTO
352User Manual 1316.0827.02 ─ 06
See also: .chapter 12.1.2, "Saving and Loading Waveform Data", on page 345.
Source
Selects the source waveform for export from the active waveforms of input channels,
math signals and reference waveforms. If an MSO option is installed, you can save also
digital channels and parallel buses.
One source waveform per file can be saved.
SCPI command:
EXPort:WAVeform:SOURce on page 760
Scope
Defines the part of the waveform record that has to be stored.
"Full wave-
form"
Saves the complete waveform record.
"Zoom"
Saves the data included in the zoom area if at least one zoom is defined
for the source waveform. The start and stop values of the area are
shown. If several zooms are defined, select the "Zoom" to be used for
export.
"Cursor"
Saves the data between the cursor lines if at least one cursor mea-
surement is defined for the source waveform. The start and stop values
of the area between the cursor lines are shown. If several cursor sets
are defined, select the "Cursor set" to be used for export.
"Gate"
Saves the data included in the measurement gate if a gated measure-
ment is defined for the source waveform. Select the "Measurement" for
which the required gate is defined. The start and stop values of the gate
are shown.
Reference for FILE Settings