User manual

Data and Results Management
R&S
®
RTO
345User Manual 1316.0827.02 ─ 06
8. To edit the image in an external application and process it further from there, tap the
"Edit image" button.
The print image is opened in the Paint application. Edit the image as necessary, and
store or print the file from there. Alternatively, save the file and close the Paint appli-
cation to return to the "Print" dialog. Then print or save the (edited) image as described
below. The changes are not shown in the preview.
9. To print the image to the selected printer, tap the "Print" button.
10. To save the print image to the specified file, tap the "Save" button.
To save it to a different file, tap the "Save As" button and select the file in the file
selection dialog box.
12.1.2 Saving and Loading Waveform Data
You can save the data of one channel, math or reference waveform to an .xml, .csv,
or .bin file. Files in .bin format can be reloaded to the R&S RTO as reference wave-
forms.
Not only a complete waveform can be saved, but also a part of it, limited by a previously
defined zoom, cursor lines, measurement gate or user-defined time values.
It is also possible to save history data to file. Furthermore, you can save a "live record"
of a running RUN Nx SINGLE acquisition to one data file.
Saving the data of several waveform sources into one file is not supported.
For details on waveform save/recall settings, see chapter 12.2.1.3, "Wave-
forms", on page 351.
● "To save a waveform or a part of a waveform to a file" on page 345
● "To export waveform data of a running acquisition" on page 346
● "To save the history" on page 117
● "To load waveform data as a reference waveform" on page 346
To save a waveform or a part of a waveform to a file
1. Press the FILE key.
2. Select the "Save/Recall" tab.
3. Select the "Waveform" tab.
4. Tap the source icon to select the waveform you want to save.
5. In the "Scope" list, select the part of the waveform record to be saved.
Zoom, cursor and gate segments require the according setup for the selected wave-
form before saving. For "Manual", enter the "Start" and "Stop" time of the section.
6. Check the file name under "Save to file" and change it, if needed. Usually, autonaming
is used.
7. Tap "Save" to save the waveform data to the specified file.
Saving, Loading and Printing Data