User manual

Mixed Signal Option (MSO, R&S RTO-B1)
R&S
®
RTO
329User Manual 1316.0827.02 ─ 06
└ D0-D7, D8-D15.............................................................................................331
└ Deskew offset...............................................................................................331
Threshold setup..........................................................................................................331
Enable bus
Enables the selected parallel bus. The corresponding signal icon appears on the signal
bar.
SCPI command:
BUS<m>:PARallel:STATe on page 740
Show dig. signals
If enabled, the selected digital channels are shown in the diagram. Each channel is dis-
played as a logic signal.
SCPI command:
BUS<m>:PARallel:DISPlay:SHDI on page 740
Show bus
If enabled, the resulting bus signal and bus values are displayed in the diagram. Select
the presentation type for the bus signal with Bus representation.
SCPI command:
BUS<m>:PARallel:DISPlay:SHBU on page 741
Bus representation
Defines how the parallel bus is displayed:
"Comb"
Displays the decoded bus signal with bus values. When at least one
digital channel changes its value, the bus value changes too.
Reference for MSO