User manual

Protocol Analysis
R&S
®
RTO
317User Manual 1316.0827.02 ─ 06
● BUS<m>:FLXRay:FRAMe<n>:DATA on page 734
● BUS<m>:FLXRay:FRAMe<n>:ADID on page 734
● BUS<m>:FLXRay:FRAMe<n>:CSSTate on page 736
● BUS<m>:FLXRay:FRAMe<n>:CSValue on page 736
● BUS<m>:FLXRay:FRAMe<n>:CYCount on page 735
● BUS<m>:FLXRay:FRAMe<n>:FCSTate on page 736
● BUS<m>:FLXRay:FRAMe<n>:FCValue on page 737
● BUS<m>:FLXRay:FRAMe<n>:FLAGs on page 734
● BUS<m>:FLXRay:FRAMe<n>:PAYLength on page 735
● BUS<m>:FLXRay:FRAMe<n>:STATus on page 732
● BUS<m>:FLXRay:FRAMe<n>:STARt on page 733
● BUS<m>:FLXRay:FRAMe<n>:STOP on page 733
● BUS<m>:FLXRay:FRAMe<n>:TYPE on page 733
10.7.1.4 FlexRay Translation Table
Translation tables are protocol-specific. A FlexRay protocol translation file contains three
values for each bus node. After a file was loaded, these values are shown in the trans-
lation table:
●
"ID Value": number of the slot in which the frame is transmitted
●
"Base cycle":
●
"Repetition":
●
"ID Name": symbolic label, name of the bus node, specifiing its function in the bus
network. The name can be changed in the table.
If "Translation" is enabled, the names ares visible in the "Decode results" table and
in the display of the decoded signal.
FlexRay (Option R&S RTO-K4)