User manual

Protocol Analysis
R&S
®
RTO
305User Manual 1316.0827.02 ─ 06
Column Description
Values Value of the data bytes. The data format is selected below the table.
Chks (hex) Checksum value
SCPI commands:
● BUS<m>:LIN:FCOunt on page 710
● BUS<m>:LIN:FRAMe<n>:STATus on page 711
● BUS<m>:LIN:FRAMe<n>:STARt on page 711
● BUS<m>:LIN:FRAMe<n>:STOP on page 711
● BUS<m>:LIN:FRAMe<n>:VERSion on page 712
● BUS<m>:LIN:FRAMe<n>:SYSTate on page 714
● BUS<m>:LIN:FRAMe<n>:IDSTate on page 712
● BUS<m>:LIN:FRAMe<n>:IDValue on page 713
● BUS<m>:LIN:FRAMe<n>:CSSTate on page 714
● BUS<m>:LIN:FRAMe<n>:CSValue on page 715
● BUS<m>:LIN:FRAMe<n>:IDPValue on page 713
● BUS<m>:LIN:FRAMe<n>:DATA on page 712
● BUS<m>:LIN:FRAMe<n>:BYTE<o>:STATe on page 715
● BUS<m>:LIN:FRAMe<n>:BYTE<o>:VALue on page 716
10.6.2.4 LIN Translation Table
Translation tables are protocol-specific. A CAN protocol translation file contains three
values for each bus node. After a file was loaded, these values are shown in the trans-
lation table:
●
"ID Value": decimal address value
●
"Data length": number of data bytes
●
"Checksum version": LIN standard
●
"ID Name": symbolic label, name of the bus node, specifiing its function in the bus
network. The name can be changed in the table.
If "Translation" is enabled, the names ares visible in the "Decode results" table and
in the display of the decoded signal.
LIN (Option R&S RTO-K3)