User manual

Protocol Analysis
R&S
®
RTO
303User Manual 1316.0827.02 ─ 06
SCPI command:
TRIGger<m>:LIN:CHKSerror on page 709
TRIGger<m>:LIN:ERRPattern on page 709
TRIGger<m>:LIN:CRCDatalen on page 710
TRIGger<m>:LIN:STANdard on page 710
TRIGger<m>:LIN:IPERror on page 709
TRIGger<m>:LIN:SYERror on page 708
10.6.2.3 LIN Decode Results
To display the decoded signal below the waveforms, enable "Decode" on the "Configu-
ration" tab.
Additionally, you can display the binary signal and the detailed decoding results using
the setting on the "Display" tab, see chapter 10.1.2, "Display", on page 251.
Data is decoded and displayed in the order of its reception. The endianess setting is not
considered for decoding. The "Decode results" box shows the detailed decoded data for
each frame as it is received.
LIN (Option R&S RTO-K3)