User manual

Protocol Analysis
R&S
®
RTO
294User Manual 1316.0827.02 ─ 06
Column Description
Values Value of the data bytes. The data format is selected below the table. Remote frames
do not transmit data, therefore "- - -" is displayed.
CRC (hex) Value of the Cyclic Redundance Check (checksum), hexadecimal value
SCPI commands:
● BUS<m>:CAN:FCOunt on page 694
● BUS<m>:CAN:FRAMe<n>:STATus on page 694
● BUS<m>:CAN:FRAMe<n>:DATA on page 696
● BUS<m>:CAN:FRAMe<n>:STARt on page 695
● BUS<m>:CAN:FRAMe<n>:STOP on page 695
● BUS<m>:CAN:FRAMe<n>:TYPE on page 695
● BUS<m>:CAN:FRAMe<n>:ACKState on page 696
● BUS<m>:CAN:FRAMe<n>:ACKValue on page 697
● BUS<m>:CAN:FRAMe<n>:BSEPosition on page 699
● BUS<m>:CAN:FRAMe<n>:BYTE<o>:STATe on page 699
● BUS<m>:CAN:FRAMe<n>:BYTE<o>:VALue on page 699
● BUS<m>:CAN:FRAMe<n>:CSSTate on page 696
● BUS<m>:CAN:FRAMe<n>:CSValue on page 697
● BUS<m>:CAN:FRAMe<n>:DLCState on page 696
● BUS<m>:CAN:FRAMe<n>:DLCValue on page 697
● BUS<m>:CAN:FRAMe<n>:IDSTate on page 696
● BUS<m>:CAN:FRAMe<n>:IDTYpe on page 698
● BUS<m>:CAN:FRAMe<n>:IDValue on page 698
10.5.1.4 CAN Translation Table
Translation tables are protocol-specific. A CAN protocol translation file contains three
values for each bus node. After a file was loaded, these values are shown in the trans-
lation table:
●
"ID Type": address type, 11-bit or 29-bit long
●
"ID Value": decimal address value
●
"ID Name": symbolic label, name of the bus node, specifiing its function in the bus
network. The name can be changed in the table.
If "Translation" is enabled, the names ares visible in the "Decode results" table and
in the display of the decoded signal.
CAN (Option R&S RTO-K3)