User manual

Protocol Analysis
R&S
®
RTO
286User Manual 1316.0827.02 ─ 06
10.5
CAN (Option R&S RTO-K3)
CAN is the Controller Area Network, a bus system used within automotive network archi-
tecture.
10.5.1 Reference for CAN
10.5.1.1 CAN Configuration
Make sure that the tab of the correct serial bus is selected on the left side.
See also: chapter 10.1.1, "Configuration - General Settings", on page 251.
Data
Sets the source of the selected data line. Waveform 1 of channel signals, math wave-
forms, and reference waveforms can be used for decoding. For triggering on a serial bus,
a channel signal is required.
SCPI command:
BUS<m>:CAN:DATA:SOURce on page 684
Type
Selects the CAN-High or CAN-Low line. CAN uses both lines for differential signal trans-
mission.
CAN (Option R&S RTO-K3)