User manual

Protocol Analysis
R&S
®
RTO
285User Manual 1316.0827.02 ─ 06
Fig. 10-10: Decode results of the UART signal
Table 10-3: Content of the "Decode results" table
Column Description
Source Line, Tx or Rx
State Decoding state of the word.
"Insuffcient waveform length" indicates that the word is not completely contained in
the acquisition. Change the horizontal scale, or move the reference point to the left
to get a longer acquisition.
Start Time of the word start (start bit)
Tx value Value of the Tx word. The data format is selected below the table.
Rx value Value of the Rx word. The data format is selected below the table.
SCPI commands:
● BUS<m>:UART:WORD<n>:COUNt on page 682
● BUS<m>:UART:WORD<n>:SOURce on page 683
● BUS<m>:UART:WORD<n>:STATe on page 683
● BUS<m>:UART:WORD<n>:STARt on page 683
● BUS<m>:UART:WORD<n>:TXValue on page 682
● BUS<m>:UART:WORD<n>:RXValue on page 682
UART / RS232