User manual

Protocol Analysis
R&S
®
RTO
255User Manual 1316.0827.02 ─ 06
Translation tables are protocol-specific. Their contents are described in the correspond-
ing protocol chapters:
●
chapter 10.2.3.4, "I
2
C Translation Table (Option R&S RTO-K1)", on page 267
● chapter 10.5.1.4, "CAN Translation Table", on page 294
● chapter 10.6.2.4, "LIN Translation Table", on page 305
● chapter 10.7.1.4, "FlexRay Translation Table", on page 317
The common settings for all protocols are:
Translation
Activates the protocol translation file to be used for decoding. The "ID Names" appear in
the "Decode results" table and in the display of the decoded signal.
SCPI command:
BUS<m>:SHOWtrans on page 662
Load from file
Selects and loads a protocol translation file. The file format is always .csv (comma-
separated values).
10.1.4 Bit Pattern Editor
If you want to enter a specified address or data pattern, the bit pattern editor helps you
to enter the pattern in various formats - decimal, hexadecimal, octal, binary and ASCII.
Basics of Protocol Analysis