User manual

Protocol Analysis
R&S
®
RTO
252User Manual 1316.0827.02 ─ 06
Bus label
Defines a label to be displayed with the bus.
SCPI command:
BUS<m>:LABel on page 644
Show decode table
Opens a table with decoded data of the serial signal. The function requires the option for
the analyzed protocol.
The decoding results are protocol-specific. They are described in the related chapters:
● I²C: chapter 10.2.3.3, "I²C Decode Results (Option R&S RTO-K1)", on page 265
● SPI: chapter 10.3.3.3, "SPI Decode Results (Option R&S RTO-K1)", on page 276
● UART: chapter 10.4.2.3, "UART Decode Results (Option R&S RTO-
K2)", on page 283
● LIN: chapter 10.6.2.3, "LIN Decode Results", on page 303
● CAN: chapter 10.5.1.3, "CAN Decode Results", on page 292
SCPI command:
BUS<m>:RESult on page 644
Show binary signals
For each configured line, the binary signal is displayed additionally to the decoded signal.
Show threshold lines
If selected, the threshold levels are displayed in the diagram.
Data format
Sets the data format for decoded data values in the "Decode results" box and on the
display of the decoded signal.
SCPI command:
FORMat:BPATtern on page 427
Basics of Protocol Analysis