User manual

Search Functions
R&S
®
RTO
249User Manual 1316.0827.02 ─ 06
Enable
If enabled, the noise reject settings for the waveform are considered for the search.
SCPI command:
SEARch:TRIGger:LEVel:NOISe[:STATe] on page 643
Absolute/Relative
Defines whether values absolute or relative to the vertical scaling are used.
SCPI command:
SEARch:TRIGger:LEVel:NOISe:MODE on page 642
Hysteresis
Defines a range in absolute or relative values around the trigger level. If the signal jitters
inside this range and crosses the trigger level, no trigger event is detected.
For hysteresis values relative to the vertical scaling, the absolute values are adapted
when either the hysteresis percentage or the vertical scaling values are changed.
For absolute hystersis values, the percentage is adapted if the absolute or vertical scaling
values are changed.
SCPI command:
SEARch:TRIGger:LEVel:NOISe:ABSolute on page 641
SEARch:TRIGger:LEVel:NOISe:RELative on page 642
Reference for Search Settings