User manual

Search Functions
R&S
®
RTO
246User Manual 1316.0827.02 ─ 06
(Relative) Stop
Defines the end value for the gate.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:ABSolute:STOP on page 584
CALCulate:MATH<m>:FFT:GATE:RELative:STOP on page 585
MEASurement<m>:GATE:ABSolute:STOP on page 572
MEASurement<m>:GATE:RELative:STOP on page 573
SEARch:GATE:ABSolute:STOP on page 633
SEARch:GATE:RELative:STOP on page 634
Zoom coupling
If enabled, the gate area is defined identically to the zoom area. If several zoom diagrams
are defined, select the zoom diagram to be used for gating. The "Start" and "Stop" values
of the gate are adjusted accordingly.
Zoom coupling can be set for measurement gates, FFT gates, and search gates.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:ZCOupling on page 586
MEASurement<m>:GATE:ZCOupling on page 573
SEARch:GATE:ZCOupling on page 634
9.3.3 Result Presentation
The following settings configure the presentation of the search results.
Result table
These settings refer to the search result table.
Reference for Search Settings