User manual

Search Functions
R&S
®
RTO
245User Manual 1316.0827.02 ─ 06
Use Gate
Performs the search only on the defined gate area of the source waveform.
SCPI command:
SEARch:GATE[:STATe] on page 632
Show gate
Displays the gate area in the source diagram.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:SHOW on page 585
MEASurement<m>:GATE:SHOW on page 573
SEARch:GATE:SHOW on page 633
Gate Mode
Defines whether the gate settings are configured using absolute or relative values.
"Absolute"
Gating is performed between the defined absolute start and stop val-
ues.
"Relative"
Gating is performed for a percentage of the value range, defined by
start and stop values.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:MODE on page 584
MEASurement<m>:GATE:MODE on page 572
SEARch:GATE:MODE on page 633
(Relative) Start
Defines the starting value for the gate.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:ABSolute:STARt on page 584
CALCulate:MATH<m>:FFT:GATE:RELative:STARt on page 585
MEASurement<m>:GATE:ABSolute:STARt on page 572
MEASurement<m>:GATE:RELative:STARt on page 573
SEARch:GATE:ABSolute:STARt on page 633
SEARch:GATE:RELative:STARt on page 634
Reference for Search Settings