User manual

Search Functions
R&S
®
RTO
244User Manual 1316.0827.02 ─ 06
Select ← Search conditions
Includes the search conditions for the selected trigger event type in the next search.
SCPI command:
SEARch:TRIGger:EDGE[:STATe] on page 614
SEARch:TRIGger:GLITch[:STATe] on page 614
SEARch:TRIGger:WIDTh[:STATe] on page 614
SEARch:TRIGger:RUNT[:STATe] on page 614
SEARch:TRIGger:WINDow[:STATe] on page 614
SEARch:TRIGger:TIMeout[:STATe] on page 614
SEARch:TRIGger:INTerval[:STATe] on page 614
SEARch:TRIGger:SLEWrate[:STATe] on page 614
SEARch:TRIGger:DATatoclock[:STATe] on page 614
Copy from A ← Search conditions
Copies the trigger event configuration from Trigger A for the selected channel source to
the search condition settings (see chapter 3.3.1, "Events", on page 58).
SCPI command:
SEARch:TRIGger:EDGE:ACOPy on page 615
Trigger level ← Search conditions
Sets the voltage level for the trigger level that is used to determine other parameters.
SCPI command:
SEARch:TRIGger:LEVel[:VALue] on page 631
Peak excursion ← Search conditions
Defines the minimum level value by which the waveform must rise or fall so that it will be
identified as a maximum or a minimum by the search functions.
This setting is only available for sources in the frequency domain.
Note that the peak excursion is a global setting and is valid for both cursor measurements
and search functions.
SCPI command:
CURSor<m>:PEXCursion on page 522
9.3.2 Scope Tab
The scope defines the search area within the source waveform. The settings are identical
to those for gate areas for measurements or FFT analysis.
Reference for Search Settings