User manual

Mask Testing
R&S
®
RTO
228User Manual 1316.0827.02 ─ 06
Make sure that the correct "Mask Test" tab is selected on the left side before you enter
the settings.
Mask segments
Defines the number and state of mask segments for the selected mask test. Here you
can:
●
Insert a new segment before the selected segment.
●
Append a new segment at the end of the list.
●
Remove the selected mask segment from the list.
●
Select the region that builds the mask.
– Inner region: the segment points form a closed geometrical shape, which is the
mask segment.
– Upper region: the segment points are connected to a line, the display area above
this line is the mask segment.
– Lower region: the segment points are connected to a line, the display area below
this line is the mask segment.
●
Enable and disable the mask segments individually. Disabled segments are not con-
sidered by running tests.
SCPI command:
MTESt:SEGMent:STATe on page 600
MTESt:SEGMent:ADD on page 601
MTESt:SEGMent:REMove on page 601
MTESt:SEGMent:INSert on page 601
MTESt:SEGMent:REGion on page 601
MTESt:SEGMent:COUNt on page 601
Definition of segment
The number of the selected segment is shown above the table. In the definition table, the
individual points of the selected mask segment are listed with exact horizontal and vertical
numerical coordinates. Here you can:
Reference for Masks