User manual

Reference Waveforms
R&S
®
RTO
212User Manual 1316.0827.02 ─ 06
"Independent"
Scaling and position can be set specific to the reference waveform.
SCPI command:
REFCurve<m>:VMODe on page 592
Vertical scale
Sets the scale factor for the reference waveform, if vertical scaling is set to "Independ-
ent".
SCPI command:
REFCurve<m>:SCALe on page 593
Vertical position
Moves the reference waveform up or down in the diagram, if vertical scaling is set to
"Independent".
SCPI command:
REFCurve<m>:POSition on page 593
Set to original
Restores the settings of the source waveform, if vertical scaling is set to "Independent".
SCPI command:
REFCurve<m>:RESTore on page 592
Vertical Stretching
Stretching changes the display of the waveform independent of the vertical scale and
position.
Enable ← Vertical Stretching
Enables and disables the vertical stretching.
SCPI command:
REFCurve<m>:RESCale:VERTical:STATe on page 593
Factor ← Vertical Stretching
A factor greater than 1 stretches the waveform vertically, a factor lower than 1 com-
presses the curve.
SCPI command:
REFCurve<m>:RESCale:VERTical:FACTor on page 594
Offset ← Vertical Stretching
Moves the reference waveform vertically. Enter a value with the unit of the waveform.
Like vertical offset of a channel waveform, the offset of a reference waveform is subtrac-
ted from the measured value. Negative values shift the waveform up, positive values shift
it down.
SCPI command:
REFCurve<m>:RESCale:VERTical:OFFSet on page 594
Horizontal Scaling
Selects the type of horizontal settings:
Reference Waveforms