User manual

Reference Waveforms
R&S
®
RTO
210User Manual 1316.0827.02 ─ 06
Ref 1/2/3/4...................................................................................................................210
Source.........................................................................................................................210
Update with selected source.......................................................................................210
Show reference waveform..........................................................................................210
Clear reference waveform...........................................................................................210
Save to or load from file..............................................................................................211
Ref 1/2/3/4
Each tab contains the settings for one of the four available reference waveforms.
Source
Selects the source waveform from the active waveforms of input channels, math signals
and other reference waveforms.
SCPI command:
REFCurve<m>:SOURce on page 590
Update with selected source
Copies the selected source waveform with all its settings to the memory of the reference
waveform.
SCPI command:
REFCurve<m>:UPDate on page 591
Show reference waveform
Displays the reference waveform in the diagram.
SCPI command:
REFCurve<m>:STATe on page 590
Clear reference waveform
The selected reference waveform disappears, its memory is deleted.
SCPI command:
REFCurve<m>:CLEar on page 592
Reference Waveforms