User manual

Mathematics
R&S
®
RTO
203User Manual 1316.0827.02 ─ 06
Vertical scale mode (Manual/Auto).............................................................................203
Vertical maximum........................................................................................................204
Vertical range..............................................................................................................204
Range..........................................................................................................................204
Phase unit...................................................................................................................204
Unwrap........................................................................................................................204
Suppression................................................................................................................204
Threshold....................................................................................................................204
Enable Math Signal
If activated, a diagram for the defined math waveform is displayed on the touch screen.
SCPI command:
CALCulate:MATH<m>:STATe on page 576
Magnitude unit
Defines the scaling of the y-axis. The display values are valid for 50Ω termination impend-
ance.
"Linear"
linear scaling; displays the RMS value of the voltage
"dBm"
logarithmic scaling; related to 1 mW
"dB"
logarithmic scaling; related to reference level
"dBμV"
logarithmic scaling; related to 1 μV
"dBmV"
logarithmic scaling; related to 1 mV
"dBV"
logarithmic scaling; related to 1 V
SCPI command:
CALCulate:MATH<m>:FFT:MAGNitude:SCALe on page 587
Reference level
Defines the reference level for dB scaling.
SCPI command:
CALCulate:MATH<m>:FFT:MAGNitude:LEVel on page 586
Vertical scale mode (Manual/Auto)
By default, the vertical scale is adapted to the current measurement results automatically
to provide an optimal display. However, if necessary, you can define scaling values man-
ually to suit your requirements.
Note: When you change the scaling values manually using the "Scale" rotary knob, the
scale mode is set to "Manual" temporarily. When you edit the math function, scaling is
automatically set back to "Auto" mode. "Manual" mode is only maintained during math
function changes if you select it yourself.
"Manual"
Enter the required values for "Vertical scale" and "Vertical offset". For
FFT, set "Vertical range" and "Vertical maximum".
"Auto"
"Vertical scale" and "Vertical offset" are read-only. For FFT, only the
"Vertical maximum" is read-only.
FFT Analysis