User manual

Mathematics
R&S
®
RTO
199User Manual 1316.0827.02 ─ 06
Enable Math Signal.....................................................................................................199
Center frequency.........................................................................................................199
Frequency span..........................................................................................................200
Full span......................................................................................................................200
Start frequency............................................................................................................200
Stop frequency............................................................................................................200
Span/RBW Coupling...................................................................................................200
Span/RBW Ratio.........................................................................................................200
Resolution BW............................................................................................................200
Window type................................................................................................................201
Frame Arithmetics.......................................................................................................201
Overlap Factor............................................................................................................201
Max frame count.........................................................................................................202
Frame coverage..........................................................................................................202
Enable Math Signal
If activated, a diagram for the defined math waveform is displayed on the touch screen.
SCPI command:
CALCulate:MATH<m>:STATe on page 576
Center frequency
Defines the position of the displayed frequency range, which is (Center - Span/2) to
(Center + Span/2). The width of the range is defined using the "Frequency span" setting.
SCPI command:
CALCulate:MATH<m>:FFT:CFRequency on page 579
FFT Analysis