User manual

Mathematics
R&S
®
RTO
182User Manual 1316.0827.02 ─ 06
5. If you need the envelope or average of the math waveform over several calculations,
change the arithmetic mode for the waveform as for channel waveforms.
See also: "Wfm Arithmetic" on page 34.
6. Close the "Math Setup" dialog box.
6.1.2 Math Setup
You can define up to 4 different math waveforms. Each waveform is defined in a separate
tab in the "Math" dialog box ("Math 1"-"Math 4").
The settings for input of mathematical formulas in optimized and advanced editors are
described in separate chapters:
● chapter 6.2.1.2, "Settings in the Optimized Graphical Editor", on page 185
● chapter 6.2.2.2, "Advanced Formula Editor", on page 188
The general settings for enabling, scaling and waveform arithmetic are:
Enable Math Signal.....................................................................................................183
Vertical Scale..............................................................................................................183
└ Vertical scale mode (Manual/Auto)...............................................................183
└ Vertical Scale................................................................................................183
└ Vertical Offset...............................................................................................183
Arithmetic....................................................................................................................183
└ Reset Now....................................................................................................183
└ Acquisition/average count.............................................................................184
└ Mode.............................................................................................................184
└ Reset mode...................................................................................................184
+Mathematical Waveforms