User manual

Measurements
R&S
®
RTO
179User Manual 1316.0827.02 ─ 06
Color table reference
Assigns one of the available color tables to the sensor results. The background of the
measurement diagrams using the selected sensor is colored according to the assigned
color table.
For details on color tables, see chapter 4.1.2.1, "Editing Waveform Colors", on page 89.
5.2.3.11 Histogram Setup
In this dialog box you configure histograms on which you can perform further measure-
ments (see chapter 5.2.1.4, "Histograms", on page 138).
Source
Defines the source of the histogram. Any input signal, math or reference waveform can
be selected.
SCPI command:
LAYout:HISTogram:SOURce on page 556
Diagram size
Defines the size of the histogram in percent of the diagram.
Mode
Defines the type of histogram.
"Vertical"
Amplitude histogram (horizontal bars across amplitude)
"Horizontal"
Time histogram (vertical bars over time). For FFT waveforms, horizontal
histograms over spectrum are not available.
SCPI command:
LAYout:HISTogram:MODE on page 557
Automatic Measurements