User manual

Measurements
R&S
®
RTO
178User Manual 1316.0827.02 ─ 06
To select the sensor and enable it for a measurement, select the chapter 5.2.3.8, "Meas-
urements - Long Term/Statistics Tab", on page 173.
See also: chapter 5.2.2.10, "Using Environment Sensors", on page 152
Environment sensor
Environment sensors measure temperature and humidity around the instrument. They
can be connected to the USB ports on the front or rear panel. The display of the sensor
measurement results is configured in the chapter 5.2.3.10, "Measurements - Sensors
Tab", on page 177.
See also: chapter 5.2.2.10, "Using Environment Sensors", on page 152
●
"Use sensor": Enables the environment measurement.
●
"Environment sensor": Selects one of the connected sensors in the upper list and the
environment measurement type in the lower list.
SCPI command:
MEASurement<m>:LTMeas:ENVSensor:STATe on page 570
Actual value
Indicates the currently measured sensor value.
Minimum value (0%), Maximum value (100%)
Minimum and maximum values define the range of values that is displayed as back-
ground color.
"Minimum value (0%)" defines the temparature or humidity value that is assigned to the
0%-color of the color table. "Maximum value (100%)" defines the value assigned to the
100%-color, respectively.
Automatic Measurements