User manual

Measurements
R&S
®
RTO
172User Manual 1316.0827.02 ─ 06
Zoom coupling can be set for measurement gates, FFT gates, and search gates.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:ZCOupling on page 586
MEASurement<m>:GATE:ZCOupling on page 573
SEARch:GATE:ZCOupling on page 634
Cursor coupling ← Gate definition
If enabled, the gate area is defined by the cursor lines of an active cursor measurement.
If several cursor measurements are enabled, select the cursor set to be used for gating.
The "Start" and "Stop" values of the gate are adjusted to the values of the cursor line
positions limiting the measurement to the part of the waveform between the cursor lines.
Gate Mode ← Gate definition
Defines whether the gate settings are configured using absolute or relative values.
"Absolute"
Gating is performed between the defined absolute start and stop val-
ues.
"Relative"
Gating is performed for a percentage of the value range, defined by
start and stop values.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:MODE on page 584
MEASurement<m>:GATE:MODE on page 572
SEARch:GATE:MODE on page 633
(Relative) Start ← Gate definition
Defines the starting value for the gate.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:ABSolute:STARt on page 584
CALCulate:MATH<m>:FFT:GATE:RELative:STARt on page 585
MEASurement<m>:GATE:ABSolute:STARt on page 572
MEASurement<m>:GATE:RELative:STARt on page 573
SEARch:GATE:ABSolute:STARt on page 633
SEARch:GATE:RELative:STARt on page 634
(Relative) Stop ← Gate definition
Defines the end value for the gate.
SCPI command:
CALCulate:MATH<m>:FFT:GATE:ABSolute:STOP on page 584
CALCulate:MATH<m>:FFT:GATE:RELative:STOP on page 585
MEASurement<m>:GATE:ABSolute:STOP on page 572
MEASurement<m>:GATE:RELative:STOP on page 573
SEARch:GATE:ABSolute:STOP on page 633
SEARch:GATE:RELative:STOP on page 634
Automatic Measurements