User manual

Measurements
R&S
®
RTO
167User Manual 1316.0827.02 ─ 06
"All on"
enables all available additional measurements.
"All off"
Deactivates all selected measurements in the table.
SCPI command:
MEASurement<m>:ADDitional on page 525
Autoset
Defines optimized settings to perform an eye measurement for the selected source.
5.2.3.5 Measurements Setup - Spectrum
Spectrum measurements are only available if a source in the frequency domain is
selected, i.e. a math waveform with an FFT operation.
Main measurement
Defines the main spectrum measurement type. This measurement is the one referred to
if the measurement waveform is used as a source for math calculations. The main mea-
surement cannot be disabled in the measurement overview.
For a description of available measurement types, see chapter 5.2.3.5, "Measurements
Setup - Spectrum ", on page 167.
SCPI command:
MEASurement<m>:MAIN on page 524
Additional spectrum measurements
In addition to the main measurement, further spectrum measurements can be performed
simultaneously. The selected measurements are displayed in an overview table. The
main measurement is also listed in the overview table, but cannot be disabled here.
Automatic Measurements