User manual

Measurements
R&S
®
RTO
162User Manual 1316.0827.02 ─ 06
Main measurement
Defines the main amplitude/time measurement type. This measurement is the one refer-
red to if the measurement waveform is used as a source for math calculations. The main
measurement cannot be disabled in the measurement overview.
The default measurement in the time domain is "Amplitude". For details on the available
measurement types, see chapter 5.2.1.2, "Amplitude/Time Measure-
ments", on page 132.
SCPI command:
MEASurement<m>:MAIN on page 524
Additional amplitude/time measurements
In addition to the main measurement, further amplitude/time measurement types can be
performed simultaneously. The selected measurement types are displayed in an over-
view table. The main measurement is also listed in the overview table, but cannot be
disabled here.
The overview table also contains the limit and margin definitions if a limit check is enabled,
see "Limit check" on page 160.
Beside the table, specific settings for the selected measurement type are shown. When
you select a measurement types, check and adjust its specific setting(s). Make sure that
the limit check is disabled to see the specific settings.
For a description of available measurement types, see chapter 5.2.1.2, "Amplitude/Time
Measurements", on page 132.
"Activate"
opens the measuement table to select individual measurements
"All on"
enables all available additional measurements.
Automatic Measurements