User manual

Measurements
R&S
®
RTO
161User Manual 1316.0827.02 ─ 06
"Margin and
Limit"
Margins and limits are checked for violation.
SCPI command:
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:LIMit on page 549
MEASurement<m>:AMPTime:LCHeck<n>:LOWer:MARGin on page 549
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:LIMit on page 549
MEASurement<m>:AMPTime:LCHeck<n>:UPPer:MARGin on page 549
MEASurement<m>:AMPTime:LCHeck<n>:VALid on page 548
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:LIMit on page 551
MEASurement<m>:EYEJitter:LCHeck<n>:LOWer:MARGin on page 551
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:LIMit on page 551
MEASurement<m>:EYEJitter:LCHeck<n>:UPPer:MARGin on page 551
MEASurement<m>:EYEJitter:LCHeck<n>:VALid on page 551
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:LIMit on page 563
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:MARGin on page 564
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:LIMit on page 563
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:MARGin on page 564
MEASurement<m>:HISTogram:LCHeck<n>:VALid on page 563
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:LIMit on page 554
MEASurement<m>:SPECtrum:LCHeck<n>:LOWer:MARGin on page 555
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:LIMit on page 554
MEASurement<m>:SPECtrum:LCHeck<n>:UPPer:MARGin on page 555
MEASurement<m>:SPECtrum:LCHeck<n>:VALid on page 554
Measurement category
For each measurement category, further settings can be configured on a separate tab.
The following categories are available:
● chapter 5.2.3.3, "Measurements Setup - Amplitude/Time ", on page 161
● chapter 5.2.3.4, "Measurements Setup - Eye/Jitter ", on page 166
● chapter 5.2.3.5, "Measurements Setup - Spectrum ", on page 167
● chapter 5.2.3.6, "Measurements Setup - Histograms", on page 168
5.2.3.3 Measurements Setup - Amplitude/Time
Amplitude and time measurements are only available for sources in the time domain.
Automatic Measurements