User manual

Measurements
R&S
®
RTO
159User Manual 1316.0827.02 ─ 06
General settings in the upper part of the dialog box relate to all measurement types.
Below, the measurement types are selected and configured. Depending on the selected
source, not all measurement types are available. In the time domain, amplitude/time and
eye/jitter measurements are available. In the frequency domain (i.e. for math channels
with spectrum results), spectrum measurements are available. For measurements based
on histograms, the histogram must be selected (available after the measurement type
has been selected).
Meas 1/2/3/4/5/6/7/8
Selects one of the eight available measurements.
State
Enables the measurement waveform.
SCPI command:
MEASurement<m>[:ENABle] on page 523
Source
Defines the source of the measurement. The source can be any input signal, math or
reference waveform. Depending on the selected source, not all measurement types are
available.
SCPI command:
MEASurement<m>:SOURce on page 523
Automatic Measurements