User manual

Measurements
R&S
®
RTO
158User Manual 1316.0827.02 ─ 06
Bottom inner
Defines an area above the low signal level which is still considered to be low level.
SCPI command:
REFLevel<m>:ABSolute:BITube on page 539
MEASurement<m>:REFLevel:RESult:BINNer on page 540
Bottom outer
Defines an area beneath the low signal level which is still considered to be low level.
SCPI command:
REFLevel<m>:ABSolute:BOTube on page 539
MEASurement<m>:REFLevel:RESult:BOUTer on page 541
Relative outer
Defines a percentage of the signal level by which the absolute signal level may be larger
than the high signal level or lower than the low signal level to be considered high or low,
respectively.
SCPI command:
REFLevel<m>:RELative:OTUBe on page 537
Relative inner
Defines a percentage of the signal level by which the absolute signal level may be higher
than the low signal level or lower than the high signal level to be considered low or high,
respectively.
SCPI command:
REFLevel<m>:RELative:ITUBe on page 538
5.2.3.2 Measurements Setup - General Settings
The "Setup" tab of the "Measurements" dialog box contains the settings for the mea-
surement types. Here you select the measurement sources and can also enable statistic
evaluation and limit checks.
Automatic Measurements