User manual

Measurements
R&S
®
RTO
142User Manual 1316.0827.02 ─ 06
4. To display an active gate area, select "Show gate".
5. To display intermediate result lines, select "Display result lines".
6. To display reference levels, select "Display reference levels".
To clear the measurement results
1. On the "Display" menu, tap "Clear screen results".
The results of all measurements are cleared.
2. To restart mesurement statistics, select "Reset now" in the "Measurement Results"
box.
The results in the selected measurement result box are cleared.
3. Alternatively, proceed as follows:
a) Press the MEAS key to open the "Measurement" dialog box.
b) Select the "Gate/Display" tab.
c) Select the tab for the measurement you want to clear.
d) Tap "Clear Results".
The results in the selected measurement result box are cleared.
5.2.2.1 Starting an Automatic Measurement
There are three different methods to start an automatic measurement, each with slightly
different effects:
●
With "Measurement" icon on the toolbar:
The icon starts the default mesurement for the previously selected waveform.
See "To start a default measurement with the toolbar icon" on page 143.
●
If no measurement is currently running: press the MEAS key on the front panel.
The key starts the default mesurement for the previously selected waveform.
See: "To start a default measurement with the MEAS key" on page 143.
(If a measurement is already running, the "Measurement" dialog box for the currently
selected measurement is opened.)
●
Select the "Meas > Setup" menu item and - after configuring the measurement - tap
the "State" option in the "Measurement" dialog box.
The configured measurement is started and the result box is displayed.
See: chapter 5.2.2.3, "Configuring Measurements", on page 143.
Automatic Measurements