User manual

Measurements
R&S
®
RTO
128User Manual 1316.0827.02 ─ 06
c1, c2 absolute
Both cursors are set to the absolute peak value.
SCPI command:
CURSor<m>:MAXimum[:PEAK] on page 521
c2 next left
Cursor 2 is set to the next peak to the left of the current position.
SCPI command:
CURSor<m>:MAXimum:LEFT on page 521
c2 next abs
Cursor 2 is set to the next smaller absolute peak (from the current position).
SCPI command:
CURSor<m>:MAXimum:NEXT on page 522
c2 next right
Cursor 2 is set to the next peak to the right of the current position.
SCPI command:
CURSor<m>:MAXimum:RIGHt on page 521
Peak excursion
Defines the minimum level value by which the waveform must rise or fall so that it will be
identified as a maximum or a minimum by the search functions.
This setting is only available for sources in the frequency domain.
Note that the peak excursion is a global setting and is valid for both cursor measurements
and search functions.
SCPI command:
CURSor<m>:PEXCursion on page 522
Cursor measurements