User manual

Measurements
R&S
®
RTO
123User Manual 1316.0827.02 ─ 06
● Press the CURSOR key.
● Tap the "Cursor"icon, and then tap the diagram where you want to set the cursors,
or draw a rectangle in the diagram to position the cursor lines.
The cursor lines appear and the "Cursor Results" box for the selected waveform
opens.
You can move the cursor lines in the diagram manually, or adjust the cursor type,
source and position in the result box.
For details on cursor measurement results, see chapter 5.1.1, "Manual Measure-
ments with Cursors", on page 121.
To disable all cursor measurements
1. Press the CURSOR key.
2. Select the "Cursor Setup" tab.
3. Tap the "All Off" button.
All cursor measurements are disabled, the cursors and cursor result boxes are
removed from the display.
5.1.2.2 Configuring a Cursor Measurement
1. If a cursor measurement was already enabled via the toolbar icon or CURSOR key,
tap the icon in the result box, or press the CURSOR key to display the "Cursor
Setup" dialog box.
Otherwise, from the "Cursor" menu, select "Setup".
2. Select the "Cursor Setup" tab.
3. Select the tab for the cursor set you want to perform a measurement on.
4. Tap the "Source" icon and select a waveform for which the measurement is to be
performed. Any input channel, math, reference or XY-waveform can be selected.
If you enabled the cursor measurement via the toolbar icon or CURSOR key, the
source is automatically defined as the selected or active waveform.
5. Select the icon for the type of cursors to be used - horizontal, vertical, or both.
6. Define the position of the cursors.
a) To define the position of the cursors manually, enter the X-position for each ver-
tical cursor and the Y-position for each horizontal cursor. Horizontal cursors can
only be positioned manually if the "Track waveform" setting is disabled.
Cursor measurements