User manual

Display
R&S
®
RTO
116User Manual 1316.0827.02 ─ 06
● "To save the history" on page 117
To open the history and get information
1. Press the HISTORY key on the front panel. The history mode is enabled and the
quick-access "History" dialog box is displayed.
The HISTORY key is illuminated as long as the history mode is active.
2. Open the full configuration dialog box:
●
Tap the
icon.
● Press the HISTORY key again.
● On the "Display" menu, tap "History setup".
3. In the "History" configuration dialog box, select the "Information" tab to see how many
history waveforms are saved, and how many can be saved as maximum.
To display a particular acquisition
1. In the quick-access "History" dialog box, enter the number of the required acquisition
in the "Current index" field. The newest acquisition always has the index "0", older
acquisitions have a negative index
2. Tap "Play" to start.
Alternatively, you can configure and start the history display from the "History" configu-
ration dialog box:
1. Open the "History" configuration dialog box and select the "Viewer" tab.
2. If the history mode is off (the HISTORY key is not illuminated), select "Show his-
tory".
The quick-access dialog box is displayed.
3. Drag the slider to the required acquisition. The current number is shown in the "Cur-
rent index" field.
Alternatively, enter the number of the required acquisition in the "Current index" field.
4. Tap "Play" to start.
To replay history waveforms
1. In the "History" configuration dialog box, select the "Viewer" tab.
2. If the history mode is off (the HISTORY key is not illuminated), select "Show his-
tory".
The quick-access dialog box is displayed.
3. Define the part of the history you want to see by doing one of the following:
● Tap "Select all" to see the complete history.
● Enter the "Start Index" of the oldest acquisition to display and the "Stop Index" of
the newest acquisition to display. All waveforms between the two indexes will be
displayed.
History