User manual

Display
R&S
®
RTO
113User Manual 1316.0827.02 ─ 06
3. In the "X-source" field, define the signal source that supplies the x-values of the XY-
diagram. Select one of the following:
● One of the waveforms of any channel
● A reference waveform
● The results of a mathematical function
4. In the "Y-source" field, define the signal source that supplies the y values of the XY-
diagram.
5. To switch the x- and y-values quickly, tap the "Swap XY" button.
6. In order to maintain a constant ratio while the x- and y-axes are adapted to the
acquired data dynamically, activate the "Constant XY-ratio" option.
If the XY-diagram is active or minimized, touch and hold the signal icon to open the "XY-
diagram" tab.
4.3.2 Reference for XY-diagram
You can display up to four different XY-diagrams that use the voltage level of a waveform
as the x-axis, rather then a time base.
Make sure to select the tab of the required XY-diagram.
Enable
If activated, the XY-waveform is active and shown in a diagram, or it is minimized in a
signal icon.
XY-diagram